Pull the cable parallel to the face of the logic board toward the optical drive opening. Pull the camera cable connector straight out of its socket on the logic board.

Pull the cable parallel to the face of the logic board toward the optical drive opening.

Pull the camera cable connector straight out of its socket on the logic board.

Bend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.īend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.

It is useful to pry upward on both short sides of the connector to “walk” it out of its socket.

Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board. If you do not disconnect the battery connector, please be careful as parts of the motherboard might be electrified. hard drive), disconnecting the battery connector is not necessary but is recommended as it prevents any accidental shorting of electronics on the motherboard. It is useful to pry upward on both short sides of the connector to “walk” it out of its socket.įor certain repairs (e.g.Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

Remove the lower case and set it aside.

Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

When removing these screws, note how they come out at a slight angle. Remove the following ten screws securing the lower case to the upper case:

When removing these screws, note how they come out at a slight angle.

Three 13.5 mm (14.1 mm) Phillips screws.

Remove the following ten screws securing the lower case to the upper case:.

Macbook pro connector to monitor